Measuretek 12R982, User'S & Technical Manual, Page: 14 / 16

Symbol Definitions
Err01 - Weight signal is too large or over range
Err02 - No proper data can be displayed
Err03
- Weight signal is too small
Err04
- Zero point is over the setting range
Err05 - Zero point is below the setting range
Err10 - EEPROM cannot be accessed
Err11 - Parameters in EEPROM ≠ backup data
Err12
- Parameters in EEPROM are out of normal range
Err20
- There is a calibration error
Err30 - Input signal is over ADC’s max. range
Err31 - Input signal is below ADC’s min. range
Err40 - Recall memory data error (address is empty)
CAP. - Capacity data
VoL.
- Voltage data
Add - Accumulation data
PC.t - Piece weight data
St.PC.t - Set and store piece weight
Addr. - Memory unit storage address
Unit
- Weighing unit
rc.PC.t - Recall the stored piece weight, tare, and unit
Lo.PC.t - Below minimum piece weight limit
SPL.PCS - Sample piece data
Hi.PCS - Upper limit piece data
Lo.PCS - Lower limit piece data
Lo.SP.t
- Below minimum sample weight limit
UnLoAd - Unload the weight
LoAd - Load the weight
inP.Ld - Input the load weight
dSP.ovr - Data length exceeds the LED display digits
CAL.oN
- Calibration enable switch is ON
CAL.oFF - Calibration enable switch is OFF
EHC ‐ C www.measuretek.net . 12 .