2
Light power settings:
Mode 1: 120° FLOOD LED only, LED set at 7% of power which is equivalent to 100 lumens (eco or survival mode)
Mode 2: 120° FLOOD LED only, LED set at 20% of power which is equivalent to 300 lumens (progression or work mode)
Mode 3: 120° FLOOD LED only, LED set at 100% of power which is equivalent to 1500 lumens (full flood mode)
Mode 4: 20°x40° SPOT LED only, LED set at 100% of power which is equivalent to 1500 lumens (full spot mode)
Mode 5: 20°x40° SPOT LED + 120° FLOOD LED, both LEDs set at 100% of power which is equivalent to 2x1500 = 3000 lumens
Color temperature:
6000K for both LED
LED type:
2 CREE XHP70 (nominal max output 4022 lumens)
Sealing
:
IP69 at -150m in water (for the lamp, the batteries boxes and our IP69 connector)
.
Warning: the lamp is waterproof only when it is connected directly to the battery box or when using our IP69 connector. This one
must be connected male and female locked correctly. Outside these two contexts, we do not guarantee the watertightness of the
lamp. Before connecting your IP69 connector always ensure the connection system in clean, check the presence and the wear status
of the two O-rings seals and if needed replace or clean them. O-Rings can be lubricated using an hydrophobic silicon based lubricant
for facilitating connector sealing and enhance the O-rings lifetime.
Materials:
Lamp, I069 connector and battery boxes are made of anodized aeronautical aluminium grade, screws are made of
stainless steel. Connecting cable are made from military / industrial grades materials. Lamp glass is made of polycarbonate of 3 mm
thickness.
Amagnetic behaviour:
Our lamp is amagnetic and fully compatible with magnetic measuring devices.
Flicker frequency in mode 1 and mode 2:
1500 Hertz (no modulation on modes 3, 4 or 5)
Temperature of use:
Minimal service temperature: -40°C (-40°F) / Maximal service temperature: +50°C (+122°F). Our lamp is equipped with a temperature
control which will reduce automatically the light power to avoid overheating which can be expected in hot environment if the lamp is
used for a long time on the high level modes.
OPERATING INSTRUCTIONS
Battery insertion, charge and good practices to enhance their lifetime:
At delivery, the Ansmann batteries we provide are charged at approximately 20% of their capacity, please ensure to fully charge them
before first use especially if you plan to need lighting for a consequent time.
Our batteries are Lithium-ion batteries. They cannot suffer from any significant impact and especially not be thrown in fire.
At end of their life batteries should be collected according to local legislation regarding batteries recycling or storage.
For charging your batteries you can connect them directly to our Ansmann chargers, for lamps equipped with our IP69 or IP65
connectors, the connector can be directly connected to the charger. In all cases, even if all our connectors are indexed (see picture
below), be careful to respect polarity while connecting the components together.
Approximate time needed to charge your batteries:
Battery type 11.1V / 2.6Ah: 3h45
Battery type 11.1V / 5.2Ah: 7h30
During charging an orange LED indicates that the charge is in progress
Once the orange LED is not lighten anymore that means the battery is fully charged.
Polarity index
