9
When the Manual Function is active either all Physical Telegrams or all Group
Telegrams or both pass the KSR-01IP without filtering. After the Switch-off time
period has elapsed KSR-01IP automatically switches back to normal operation. To
configure the Manual Function and set the Switch-off time use the parameter tab
General like shown in chapter 4.1 General. After switching back from Manual
Function to normal operation the latest downloaded parameter setting / filter table
entries are active again.
3.5.2 Factory Reset
A long press (≈ 15 sec) of the Function Button soon followed by a second press for
some seconds executes the Factory Reset. After the first press the LED display
lights different (see table 4). After the second press all parameters will be set to
factory default (incl. physical address). Subsequently, LEDs show the normal
display again.
When Boot Mode is active the Function Button executes the Factory Reset in a
different way. After pressing the Button for about five seconds the LEDs light with
green color. After second press (about two seconds) the parameters will be set to
factory default (incl. physical address) and LEDs again display Boot Mode is on.
Note After a factory reset executed in Boot Mode the KSR-01IP stays in Boot Mode.
3.5.3 Boot Mode Activation
For Boot Mode activation the firmware update process must be executed. During the
process, the Function Button must be pressed to enter Boot Mode (see chapter 5.4).
Figure 5: Boot Mode is active