Technical Manual IP-Router SCN-IP100.01
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49-2263-4588 • [email protected] • www.mdt.de
10
3.3 Routing (KNX --> IP)
The following parameters can be set at the Routing KNX --> IP:
Figure 8: Routing (KNX --> IP)
Group telegrams (main group 0 to 13):
Block:
No group telegrams of this main group are routed to IP.
Route:
All group telegrams of this main group are routed to IP independent of the filter
table. This setting is for testing purposes only.
Filter:
The filter table is used to check whether or not the received group telegram should
be routed to IP.
Group telegrams (main groups 14 and 15):
Block:
No group telegrams of main groups 14 and 15 are routed to IP.
Route:
All group telegrams of main groups 14 and 15 are routed to IP.
Group telegrams (main groups 16 to 31):
Block:
No group telegrams of these main groups are routed to IP.
Route:
An additional page appears on which the routing of main groups 16 to 31 can be
disabled or enabled in pairs.
Note:
The group addresses of main groups 16 to 31 are re-served addresses that can be used for special
applica-tions (e.g. in Easy Mode). These group addresses are not available in the ETS.
Physically addressed telegrams:
Block:
No physically addressed telegrams are routed to IP.
Route:
All physically addressed telegrams are routed to IP.
Filter:
The physical address is used to check whether the received physically ad-dressed
telegram should be routed to IP.
Broadcast telegrams:
Block:
No received broadcast telegrams are routed to IP.
Route:
All received broadcast telegrams are routed to IP.
