MDT Technologies AKK-03UP.02, Technical Manual

Page: 38 / 78

Technical Manual Switch Actuator 3-fold, FanCoil
MDT technologies GmbH
•
51766 Engelskirchen
•
Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49
-2263-4588
• knx@mdt.de • www.m
dt.de
38
5.3.6 Priority/Forced control
The following figure shows the parameter priority/forced control:
Figure 22: Priority/Forced control
The following settings are available:
ETS-text
Dynamic range
[default value]
comment
Priority/Forced Control

not active

2 Bit forced control

1 Bit priority ON

1 Bit priority OFF
Activation of the forced
control/priority function
Release time for forced
control (0 = not active) 0-600min
[0 min]
Activation of a release time
from the priority/forced
control into the normal state.
Behavior after forced
control/priority

Off

no change

start time of staircase
light
Setting of the behavior after
deactivating priority/forced
control.
Table 29: Priority/Forced control
The priority/forced operation cause the priority switching of output. By using the release time, the
priority/forced control can be deactivated automatically and the channel changes into the normal
state.
The followings actions can be performed after deactivating the priority/forced control:

Off
The channel is switched off.

start time of staircase light
The channel is switched on for the time of the staircase light.
The following table shows the communication object:
Number Name Length Usage
5 Forced control/Priority 1 Bit Activation/Deactivation of the forced
control/priority
Table 30: Communication object priority/forced control