MDS LEDR 1400F, Installation & Operation Manual

Page: 43 / 154

MDS 05-3627A01, Rev. D LEDR Series I/O Guide 35
IO Configuration
This screen is used to set or display the data clocking method. For syn-
chronization purposes, several different clocking schemes can be used.
See
Table 10 on Page 23 for the combinations of radio bandwidth, data
rates and modulation types available for subrate radios. Table 11 on
Page 24 contains the same information for fullrate radios.
NOTE:
For subrate models: LEDR 400S/900S/1400S
Earlier versions of the software may display the Clock Mode
as
NORMAL
instead of
INTERNAL
.
This screen is used to set or display the payload data interface. The
available selections are E1, T1 and EIA530, depending on hardware
configuration of the LEDR radio.
This screen is used to set or display the Channel Associated Signaling
(CAS) status. The available selections are
Enabled
and
Disabled
.
This screen will only be functional in radios factory-equipped to support
CAS. Consult the factory if you require this service.
This screen is used to set or display the current span mapping configu-
ration. The entry consists of from 1 to 4 alpha-numeric characters spec-
ifying line interface to span mapping. Valid numbers are 1–4. Valid span
characters are a–d.
Example: Entering 1a 2b 3c 4d asserts the following:
maps line 1 to span a
maps line 2 to span b
maps line 3 to span c
maps line 4 to span d
CCCClllloooocccckkkk MMMMooooddddeeee
IIIINNNNTTTTEEEERRRRNNNNAAAALLLL
For the NMS command-line
equivalent,
see “date” on
Page 57
.
IIIInnnntttteeeerrrrffffaaaacccceeee
EEEE1111
For the NMS command-line
equivalent,
see “interface”
on Page 62
.
CCCCAAAASSSS EEEEnnnnaaaabbbblllleeee
DDDDIIIISSSSAAAABBBBLLLLEEEEDDDD
For the NMS command-line
equivalent,
see “modem”
on Page 71
.
LLLLiiiinnnneeee mmmmaaaapppp
1111aaaa 2222bbbb 3333cccc 4444dddd
For the NMS command-line
equivalent,
see “linemap”
on Page 66
.