D-Verter
User Guide, Rev: A/b
9 / 23
S
TARTING THE
D-V
ERTER
Connect
the data wiring (DMX or RDM), if you want to use a remote control.
Plug
the powerCON connector (100–250 VAC, 50/60 Hz, 50 W).
Connect the gas line and set the pressure between 60 psi (414 kPa) to 100
psi (689 kPa) max
Switch On
the power.
The MDG
D-Verter
TM
will display during two (2) seconds, the following message:
D-Verter by MDG
V: x.xx – F: y.yyy
where ‘x.xx’ is the version of your
D-Verter
, and ‘y.yyy’ is the firmware of the program.
The program will load the configuration parameters, saved in the EEPROM memory. These
parameters are saved each time the program is modifying them (User or Configuration).
Finally, the screen will display the menu.
