![background image](http://html1.mh-extra.com/html/mdc/robson-xtt-2021/robson-xtt-2021_owners-manual_1757210039.webp)
www.marketdirect.com.au
Ph: 1300 494 494
35
Using Wheel Chocks and Ramps
The stabiliser legs on your camper are not designed for supporting the full weight of the trailer, they are there to
stabilise it once it is level. Using your stabilisers as a lifting mechanism will void your warranty as will extending them
with a “rattle gun” or “impact wrench”. Levelling front to back can be done by raising and lowering the jockey wheel
prior to adjusting the stabiliser legs. Getting the trailer level from left to right should be done with drive on stepped
ramps as illustrated below. Once levelled the legs can be lowered to keep the trailer stable. On soft ground you may
want to use timber sole boards under the stabiliser feet.
Operating the Jockey Wheel
The rated load capacity of a jockey wheel is achieved when the jockey wheel is retracted to its lowest position
When moving the trailer on the jockey wheel, always lower it as far as possible but still allowing the wheel to swivel
as you steer the trailer.
Stabiliser Legs
Stabiliser legs are installed to stabilise the camper when setup. Stabiliser legs should never be used to jack a trailer
as they are comprised of small bevel gears held in place by small roll pins that will break if overloaded. Stabilisers
are best set vertical or 90 degrees to the chassis where possible. When set and an angle the user must be careful
not to overload them causing locking pins or the leg itself to bend. Never use impact wrenches to wind the legs, the
impact may damage the gears. When using a power tool, use an electric drill with a safety clutch set low to medium
to avoid injury or damage to the stabilisers.
Summary of Contents for ROBSON XTT 2021
