MDC ROBSON XTT 2021, Owner'S Manual

Page: 38 / 87

www.marketdirect.com.au
Ph: 1300 494 494
34
Setting up your Camper
Choosing a Spot to Set Up
When choosing a spot to set up your camper, start with a flat area with no overhanging trees. Birds and bats
occupying trees can defecate leaving droppings on your camper that can damage paint and canvas and leaves and
sap can also taint the canvas. Ensure you are not camping in an area prone to flooding or with bad drainage in the
event of rain. Even the slightest hollow in the ground can put you in a mini lake. In hot weather if possible, set your
camper up so the sun’s arc goes from front to back or back to front with the annex/awning in the general direction
the sun is arcing across. Doing this will keep the bulk of the camper in shade and the inside cooler as it will be
protected by the tropical roof and shaded by the awning.
Levelling Your Camper
The stabiliser legs on your camper are not designed for supporting the full weight of the trailer, they are there to
stabilise it once it is level. Using your stabilisers as a lifting mechanism will void your warranty as will extending them
with a “rattle gun” or “impact wrench”. Levelling front to back can be done by raising and lowering the jockey wheel
prior to adjusting the stabiliser legs. Getting the trailer level from left to right should be done with drive on stepped
ramps as illustrated below. Once levelled the legs can be lowered to keep the trailer stable. On soft ground you may
want to use timber sole boards under the stabiliser feet.
Site Power
The Projecta charger in your camperis connected via the 15A exterior socket. To use site power, you will require
a 15A power lead connected to a 15A outlet (figure 1). In the event a 15A outlet is unavailable you will need a
conversion box that will step up from 10A to 15A with a safety switch. Never leave power leads coiled when in use,
lay the lead out back and forward in a manner that won’t be a trip hazard or risk damage to the lead.