MDC FORBES 15+ 2021, Owner'S Manual

Page: 45 / 87

www.marketdirect.com.au
Ph: 1300 494 494
41
Spare Part Numbers
Hub & Suspension Components
Timken Bearing (inner & outer bearings) 25590
Bearing Cone (Inner and outer bearings) 25520
Bearing Seal 55 x 85 x 12mm
50 x 50mm square Poly Orange Bush YJJJ016
Steel Bush Insert 30 x 114mm YZCN002
Adjuster Cam YDS030
LHS Backing plate Assemble (with pads) DM00025
RHS Backing Plate Assembly (With Pads) MJFCX003
Crown Nut M38 LGPJ002
14mm Wheel Stud YHJL110
14mm Wheel Nut YZCQ029
½” UNF Wheel Stud YZCQ009
½” UNF Wheel Nut YZCQ007
Grease Nipple 6mm
Moisture and Mould Protection
Condensation:
Condensation is cause by a difference in ambient temperature and a surface. If the surface is sufficiently colder than
the ambient temperature and there is a degree of humidity, condensation will form on the surface. The only means of
stopping it is good ventilation, a heater or running air conditioning. When condensation occurs the Caravan should
be thoroughly aired and dried to protect finishes and avoid mould.
Protecting from Mould
Mould is very difficult to clean once a porous surface is affected. There are several ways you can prevent the
occurrence of mould on your caravan. Never leave your Caravan packed away wet. If you must leave a campsite with
wet canvas or a damn interior, be sure to open and dry out your tent thoroughly at the very first opportunity when
you get home. Mould can develop in just a couple of days so don’t take the risk.
When packing up dry, it is important to check under the mattress that there is no build-up of condensation overnight.
Body heat on a mattress can create enough temperature difference
with the exterior for moisture to form under it. If left unchecked
this can cause mould when your caravan is stored. An antibacterial
mould killer such as Glen20 is recommended as a mould deterrent
to be sprayed through the caravan prior to storage or on canvas
during prolonged exposure to damp conditions.