FIG.3 BILLIARD TABLE ASSEMBLY
FIG.4 BASKET OF BILLIARD
TABLE ASSEMBLY
8. Attach two previously-assembled Legs (#4 and #5) to the end of Billiard Cabinet(#1) using
four Bolts (#8) per Leg.
See FIG.3.
9. Attach the other two previously-assembled Legs (#4 and #5) to the other end of Billiard
Cabinet(#1) but using only two Bolts (#8) on the sides of each Leg.
See FIG.3.
Note: Please do not use any screws on the holes in the end apron of Billiard at this step.
The bolts will be added later for the crooked Pole (#19). See FIG.5A
10. Attach the Leg Side Panel (#6) between the inside of Left and Right Legs using four Screws
(#18) per Leg Side Panel.
See FIG.3.
12. Attach the Corner Basket (#23)
and Side Basket (#24) to Billiard
Cabinet (#1) using two Screws (#15)
per Basket. See FIG.4
Note: Repeat the steps above for
the other baskets.
FIG.3
5
24
15
23
15
HOLD TABLE
CABINET
DO NOT
HOLD THE
LEGS
DO NOT LEAN THE
TABLE ON ITS LEGS!
CAUTION:
Two strong adults are recommended to turn the table over as shown.
1. Lift the table off the ground.
2. Turn the table over.
3. Place it on all four feet at the same time on the ground.
11. Lift the table assembly from the floor
with two strong adults, turn it over,
and set table on its legs in the location
where you play. Go back and make sure
that all connections are tight.
8
8
8
8
1
4
5
5
4
NO BOL
TS THIS SIDE.
18
6
This is the hole for Rivet Plug (#25).
