
EN
INSTALLATION OF RECESSED CONTROL PANEL CODE 4018003
The recessed control panel was built for all MAESTRO products, such as the inserts, which are mainly snapped into a decorative cladding.
This panel is compatible with any MAESTRO appliance.
MECHANICAL INSTALLATION
Install the recessed box of the MAESTRO panel into the wall or plasterboard using foam or fast setting cement like for standard electric
boxes, or, when installing on plasterboard, into the arranged holes to screw the metal box on an upright of the structure.
Bring an appropriately sized electric conduit from the appliance to the inside of the recessed box to pass the RJ11 plug of the connection
cable. It is recommended to use an electric conduit at least 20 mm large which corresponds to the size of the pre-perforations inside the
electric box of the panel
ELECTRICAL INSTALLATION
Pass the supplied electric cable into the conduit. The cable must not be more than 2 linear meters long.
The cable and/or conduit must never pass through areas in contact with the direct heat of the appliance or of the combustion chamber.
Connect the RJ11 plug (similar to a twisted pair cable) to the specific connector on the board (see picture) and on the display
PLEASE NOTE Inside the box secure a “coil” of cable with the provided clamp so that the display can be taken
out for updating.
Technical Dept. - All rights reserved - Reproduction is prohibited
4-INSTALLATION
33