McQuay MDS030A, Service Manual

Page: 28 / 166

22 Service Manual SM-MDS_(ii)
3.4.1 Wireless Handset G17
1. Transmission Source
2. Signal Transmission Indication

Blink to confirm that the last setting has been transmitted to the unit.
3. Temperature Setting

Temperature setting range is from 16°C to 30°C (optional setting 20°C to 30°C).
4. Personalize Setting

Press and hold for 3s, then will blink. Press again to cycle between and ..

Set the desire setting, then leave the handset for 4s without pressing any key and it will save the setting
into the program.

Press once to activate the P1 setting, press again to cycle between P1 and P2.

Press any key to deactivate the personalize setting.
5. Automatic Air Swing (optional)

Press the SWING button to activate the automatic air swing function. Press again to stop the louver
at the desired direction.
6. Ionizer Function (For WM - G series only)

Press button to activate the negative ion function, which will refresh the indoor air effectively.
7. Sleep Mode Setting

This function is available under COOL, HEAT and AUTO mode.

When under cooling mode, the set temperature is increased by 0.5°C after 30 minutes, 1°C after an
hour, and 2°C after 2 hours.

When under heating mode, the set temperature is decreased by 1°C after 30 minutes, 2°C after an hour,
and 3°C after 2 hours.
8. Operating Mode

Press the MODE button to select the type of operating mode.

For cooling only unit, the available modes are: COOL, DRY and FAN.
9. Fan Speed Selection

Press the button continuously will toggle the fan speed in the following order:
Low Med High Auto

Stop pressing when the desired fan speed appears on the display screen.
3