McQuay 5CKWS 10CR, Installation Manual

Page: 7 / 96

1-3
English
5CKWS-CR
Fan Coil Unit
Drain Hose
Front Panel
Air Filter
(behind the grille)
Air Discharge Louver
IR Receiver
LED Light
Air Intake Grille
Refrigerant Piping
Wired
Remote Control
INSTALLATION DIAGRAM
5WSS-AR
Water Source Heat
Pump Unit
Wireless
Remote Control
Preliminary Site Survey
• Electrical supply and installation is to conform to local authority’s (e.g. National Electrical Board) codes and regulations.
• Voltage supply fluctuation must not exceed ±10% of rated voltage. Electricity supply lines must be independent of welding
transformers which can cause high supply fluctuation.
• Ensure that the location is convenient for wiring, piping and drainage.
•
The fan coil unit must be installed in such that is free from any obstacles in path of cool air discharge and warm air return,
and must allow spreading of air throughout the room (near the center of the room).
• Must be provide clearance for the fan coil unit from the wall and obstacles as shown in the figure.
INSTALLATION OF THE FAN COIL UNIT
Max. 0.3 m
Min. 0.5 m
Min. 0.5 m Min. 0.5 m
Min. 1.0 m
Max. 3.0 m
Floor
Obstacle
Beam
• The installation place must be strong enough to support a load 4 times the fan coil unit weight to avoid amplifying noise
and vibration.
• The installation place (hanging ceiling surface) must be assuring levelness and the height in the ceiling is 350 mm or more.
• The fan coil unit must be away from heat and steam sources (avoid installing it near an entrance).