Page 8
ADDING WIRELESS DETECTORS
WIRELESS PIR, REED, SMOKE DETECTOR, EMERGENCY PENDANT.
1.
Enter Programming Mode
See ENTERING PROGRAMMNG MODE (page 3).
2.
Press button 3 repeatedly until the channels lights
indicate the output channel you wish to program.
Select the channel that you wish to be activated by
the detector.
Press button 2 repeatedly until the feature lights are
on as shown.
4.
Press button 1 to set the feature light(s) to not
flashing.
NOTE: By default the feature light(s) will be
flashing, if not do not press button 1.
3.
Press button 2 repeatedly until the feature lights are
off as shown.
4.
Press and hold button 1 until the channel light(s)
begin to flash.
5.
Now trigger the new detector; the channel light(s)
should stop flashing. Note that detectors are high-
powered and should be triggered at least 5 meters
away from the unit.
5.
Press and hold button 2 on the remote control until
the lights start scrolling.
The detector has now been learnt in.
)
)
)
)
)
)
