PBX
gateway
QIG Page 16 G-6000G-SMM
Synchronous-Serial Device (RVP_Direct)
Introduction
This section of the manual provides the necessary information to configure the
PBXgateway for connection to a synchronous-serial device. The units are
programmed at the factory with “default” settings providing basic parameters
to accommodate many network environments.
Figure 7. RVP_Direct Typical Installation
Prerequisites for Configuration
!
Both units must be installed properly and the network link
between both devices must be operational.
Basic Configuration
You must ….……
to…………
Default settings
Refer to System Admin.
Guide …….
Set the Phone Port
compression algorithm
for all active phone
ports.
Provide adequate bandwidth
for all users.
ADPCM 32 (on
all phone ports)
Chapter 4 -
Port set up
Enable/Disable WAN
ports
Enable WAN ports to
connect to network device.
WAN 1 - Enabled
Chapter 4 -
WAN set up
Set the Sync Rate of the
WAN port
Match the data rate (sync
rate) of the network device.
384,000 kbps
Chapter 4 -
WAN set up
Set the mode (interface
type) of the WAN port
(v.35, RS-232, RS-530)
Match the interface type of
the network device.
V.35
Chapter 4 -
WAN set up
Increase Jitter Delay
(for Frame Relay installs
only)
Match network
characteristics of the Frame
Relay network.
0
Chapter 4 -
Setting Voice
Parameters
Table 7. RVP_Direct Configuration Steps
Punch Block
Public
DSU/CSU
DSU/CSU
PBX
Branch Office
Corporate Facility
Punch Block
PBX
gateway
EXT
ender 6000
Router
Router
LAN
LAN