21
2. The MCT80 will switch Off and the LED above
the STANDBY/ON Push-button will illuminate
Red in color. Press the (Power) Push-button to
switch the MCT80 On.
3. To re-active the Auto Off Feature, press and hold
in the Power Push-button on the Remote Con-
trol for about 5-10 seconds, at which time the Front
Panel Display indicates “Auto STBY On”. Refer to
figure 45.
4. The MCT80 will switch Off and the LED above
the STANDBY/ON Push-button will illuminate
Green in color. Press the (Power) Push-button
to switch the MCT80 On.
Resetting the MCT80
In the unlikely event the MCT80 stops functioning,
first try resetting the Main (System) microprocessor
by performing the following:
1. Simultaneously press and hold in the Front Panel
DISC LAYER and the STANDBY/ON Push-
buttons until the illumination of the LED above the
STANDBY/ON Push-button goes Off. The MCT80
will then switch Off.
2. Press the STANDBY/ON Push-button to switch
the MCT80 back On.
If the MCT80 is still not functioning properly, reset
the Secondary (Transport) microprocessor by per-
forming the following:
1. Switch Off A.C. Power going to the MCT80.
Note: Temporarily, connect the AC Power Cord
coming from the MCT80 into an AC Power
Strip with an On/Off Switch. Position the
A u t o S T B Y O n
Figure 45
How to Operate the MCT80, con’t
AC Power Strip so the On/Off Switch on
the strip is in very close proximity to the
MCT80 Front Panel STOP Push-button (the
MCT80 Remote Control STOP Push-button
will not work for resetting the microproces-
sor).
3. Press and Hold-In simultaneously the NEXT
:
and STOP
<
Push-buttons and then switch On the
AC Power Strip.
4. The Front Panel will indicate “RESET” and then
go through the process of reading the Disc for
playback. At this time release the NEXT Push-
button and then the STOP
<
Push-button.
5. The MCT80 will resume normal operation.
Summary of Contents for MCT80
Page 9: ...9 Notes...
