on the MCD7009, by sending control signals to the player through the Control Center sensor
in either the main or a remote area.
5. DATA IN
Connect a DATA cable from the MCD7009 DATA IN (5) jack to a CD DATA Port on a Mcln-
tosh Control Center or Remote Control System. This allows the Mclntosh Control Center Remote
Controller to operate a wide range of functions on the MCD7009 player, from either the main
or remote area
Refer to the drawings of the various Mclntosh hand held Remote Controllers in the manual
section HOW TO USE THE MCD7009 WITH OTHER MclNTOSH REMOTE CONTROL PRO-
DUCTS. These drawings show which pushbuttons on each specific Controller are active for
controlling the MGD7009. The drawings also indicate several pushbuttons that perform player
functions that are different from the markings on the Remote Controllers.
A Keypad can also be used to control the MCD7009 in a remote area. Refer to the keypad
drawing which indicates which pushbuttons are active with the MCD7009.
The MCD7009 Remote Controller can also be used in a remote area of any Mclntosh remote
control system to operate the player by sending control signals to a wall mounted IR sensor.
All the MCD7009 Remote Controller pushbuttons are active in this configuration.
A Data cable uses single conductor shielded wire with 1/8" mini phone plugs. Connections
are to the sleeve (-) and tip (+) of the plug.
(Do not connect a DIN CONTROL cable to the MCD7009 when the DATA In is being used.)
6. AC POWER
Connect the MCD7009 AC Power Cord to a 120 volt, 50Hz/60Hz outlet.
7. LINE OUT, L AND R
Connect shielded cables from the L (Left) and R (Right) LINE OUT jacks to the CD inputs of
a Control Center or Preamplifier. Similar high level audio inputs such as Auxiliary or Tape can be
used, but you will then not be able to control the player with the Control Center Remote Controller.
THE REAR PANEL
AND HOW
TO
CONNECT
7
and NEXT Track
Center Remote Controller will then operate PLAY, STOP, BACK Track
The last page of this manual folds out to show a drawing of the rear panel of the
MCD7009. The letters on the drawing refer to the information that follows.
1. DIGITAL OUT: OFF/ON
Turns the OPTICAL and COAXIAL, DIGITAL OUT connectors ON or OFF.
2. OPTICAL DIGITAL OUT
1. Set the DIGITAL OUT switch (1) to the ON position.
2. Remove the protective cap from the MCD7009 OPTICAL DIGITAL OUT connector.
3. Connect an Optical cable from the MCD7009 OPTICAL DIGITAL OUT to the Optical in-
put of an external DA Converter.
4. Connect the analog outputs of the DA Converter to the CD inputs of the Control Center
or preamplifier.
3. COAXIAL DIGITAL OUT
1. Set the DIGITAL OUT switch (1) to the ON position.
2. Connect a coaxial cable (RG6 or RG59U) from the MCD7009 COAXIAL DIGITAL OUT
to the coaxial input of the external DA Converter.
3. Connect the analog outputs of the DAC to the CD inputs of the Control Center or
preamplifier.
4. CONTROL
(This connector is used with a Mclntosh Control Center or Remote Control System that does
not have a CD DATA PORT.)
Connect a 7 pin DIN cable from the MCD7009 DIN CONTROL socket to a matching DIN
CD CONTROL socket on a Mclntosh Control Center or Remote Control System. The Control
