Elektronik GmbH
USB hub 3.0 8-Port
Manual
Seite 16 von 22
The USB hub can be configured using the configuration dialog. This is located in the standard settings under
View –> USBHub 1 –> USBHub 1 config
:
9.3.
USB hub configuration
On power up, the corresponding USB port is switched on when the box is checked.
On power up, the corresponding relays multiplexer output is switched on when the box is checked.
Turns device detection on. In DCP mode and charger emulation, device detection is necessary for
correct functioning. Devices that consume less than 1mA from the USB port are frequently not
detected and the port is then not released. For this case, device detection can be turned off.
Places an exception for the corresponding USB port Such a port will not be influenced by standby.
The same for the relay multiplexer outputs.
Places the corresponding port into SDP, CDP, DCP, or charger emulation mode.
This function reports an excess current event to the operating system and leaves further handling to
it. Without this function, the port will turn back on as soon as the overload is removed.
Sets the current limitation per port.
1
2
3
4
5
6
7
1
2
3
4
5
9
12
13
8
10
11
6
7
8
