18 –
English
Driving
6
Move the throttle in between positions 1 and 2.
7
Turn the ignition key to the start position.
8
When the engine starts release the ignition key
immediately back to neutral position.
9
Move the throttle backwards gradually once the engine
has started. Let the engine run at moderate speed or half
throttle for 3-5 minutes before subjecting it to heavy load.
10 Set the required engine speed with the throttle control.
Starting the engine with a weak
battery
If the battery is too weak to start the engine, it should be
recharged. Charge the battery for 4 hours at max. 3 amp.
When jump leads are used for emergency starting, follow the
procedure below:
Connecting the jump leads
•
Connect each end of the red cable to the POSITIVE pole
(+) on each battery, exercise care not to short circuit any
of the ends against the chassis.
Connect one end of the black cable to the NEGATIVE pole
(-) on the fully charged battery.
•
Connect the other end of the black cable to a good
CHASSIS EARTH, away from the fuel tank and the
battery.
Remove the cables in the reverse order
•
The BLACK cable is removed from the chassis and then
the fully charged battery.
•
Finally the RED cable from both batteries.
Driving the Rider
1
Release the parking brake.
M105-85F
Release the parking brake by first pressing down the
parking brake pedal and then releasing it.
M125-85FH
Release the parking brake by moving the lever
backwards.
2
M105-85F
Disengage the engine and select the required gear.
Gradually release the clutch pedal.
IMPORTANT INFORMATION
If the engine does not start wait about 1 minute before trying
again.
!
WARNING! Never run the engine indoors, in
enclosed or poorly ventilated areas. The
exhaust fumes contain toxic carbon
monoxide.
!
IMPORTANT INFORMATION Your Rider is
equipped with a 12-volt system with negative
earth. The other vehicle must also have a 12-
volt system with negative earth.
2
1
3
