11
A
A
5)
Raise Robocut toolbar to connect with lugs on flailhead mounting bracket.
6)
Fasten head unit to Robocut toolbar using head unit fixings (6x Nuts & Bolts) - tighten fixings fully.
7)
Remove expansion vessel from drain line and connect head unit hoses to the Robocut hydraulics.
Refer to the hydraulic connections page for
hydraulic coupling information.
Store expansion vessel in a safe location; it
must be refitting to the drain line whenever
the head unit is removed from the machine.
8)
Configure the following settings in the Robocut control panel:
Attachment Settings;
attachment type & width.
Float Settings;
float calibration (initial install only).
Removing the Head Unit
Removal of the head unit is a reversal of the attachment procedure. Select a firm level site
on which to remove and store the head unit.
Refer to RC56/75
operator manual
for information
on configuring
these settings
TOOL
UP