McConnel ECON HEDGEMASTER Mk3, Operator'S Manual

Page: 60 / 78

43
PRE-WORK PREPARATION & PRECAUTIONS
IMPORTANT: Always read the book first before attempting to operate the machine –
practise operating the machine, without the rotor running, in a safe open space until you
are fully familiar with all controls and functions of the machine. Only begin using the
machine for work when you are confident that you have mastered the controls and
operation sufficient for safe use of the machine.
Pre-work Machine Checks
Prior to use of the machine always check all bolts are tight and that the torque figures are
correct for the specific locations indicated below:
EMERGENCY STOPPING
In all emergency situations machine operation and functions must be stopped immediately;
Stop PTO operation using the tractor controls then immediately kill electrical power to the
machine using the Off (Emergency Stop) switch on the machine’s control unit.
WARNING: Auto-Reset Machines
When the Auto-Reset feature is active the machines arm set is capable of
unintentional movement even when the PTO is switched off and stationary.
Always ensure that electrical power to the machine is switched off using the
Off (Emergency Stop) switch on the machine’s control unit in emergency
situations and/or when the machine is not being operated.
WARNING: Cable Operated Machines
In certain conditions, and/or if the Auto-Reset feature is active, the arm sets
on cable operated machines possess the potential to move unintentionally,
even when the PTO is switched off and stationary, if the levers were to be
accidentally operated. Care must be adopted to avoid any movement of the
levers when the machine is not being operated. Ensure arm sets are lowered
fully to the ground when the machine is parked up or not in use.
52 Nm
Roller End Capscrews
Motor Bolts
Flail Bolts Rotor Bolts
Roller Bracket Bolts
203 Nm