47
/F[0|1]
Flow Control (0=XON/XOFF, 1=RTS/CTS)
/G[0|1]
General Call Control (0=Disable, 1=Enable)
/H[0|1]
Hex Only Display Control (0=Disable, 1=Enable)
/Ixx
Set i2cStick’s Own I2C Slave Address
/K[0|1|2|3]
I2C Bus Clock Rate Control (0=23, 1=86, 2=100, 3=400 KHz)
/M Menu
Display
/N([0|1|A|R]) iNterrupt Signal Monitor/Control/Status
(0=Disable, 1=Enable / A=Assert, R=Release / <CR>=Status)
/O
Open I2C Connection
/(*)Rn
Master Rx Message *=No Stop
/S(text)
Slave Tx Message
/(*)T(text)
Master Tx Message *=No Stop
/Un
Set I2C Bus Time-oUt in msec 0=Disable)
/V
Display Firmware Version (Major XX.XX Minor)
/X[...]...
Extended Cmds (See Prompt or User's Guide)
/(*)Y
Display Tx bYte Count *= with last received Ack bit
Interrupt Signal Control/Status
The i2cStick does not support the INT signal. The following commands and
responses are provided for backward compatibility only.
Control
Command:
/N0[CR]
Disable Monitor
/N1[CR]
Enable Monitor
/NA[CR] Assert INT Signal
/NR[CR] Release INT Signal
Status
Command:
/N[CR] Status
Response:
/NSA
INT Asserted
/NSR
INT Released
Response: *
'i2cStick Ready
Default Setting: /N0, /NR
Open I
2
C Connection
Activates i2cStick as an active device on the I
2
C Bus.
Command: /O[CR]
'Open I
2
C Connection
