McAlpine Hussmann VLL726BL, Installation And Maintenance Instructions Manual

Page: 11 / 33

Page
11
2. Loosen the grub screw on the foot of the rear post.
Front bolt
Grub screw
Rear bolt
3. Adjust the post by loosening or tightening the rear bolt. This will tilt the
post forward or backwards. You may need to slightly loosen the front bolt.
You will need to adjust all the posts on a cabinet.
4. When the posts are aligned with that of the adjacent cabinet retighten the
grub screw on the foot of the rear post.
Adjusting the glass
1. The glass can be moved laterally to even out the gaps between each piece
of glass.
2. Lift the glass to the fully open position
3. Loosen the grub screw on the locking plates at each hinge.
Hinge attachment screws
Locking plate grub screw
4. Loosen the hinge attachment screws on each hinge. This will allow the
glass clamp to be moved.
5. Tighten the hinge attachment screws on the hinges before lowering the
glass to check the new position.
6. When the new position is attained check again that the hinge attachment
screws are tight. If they are not the glass will sit at different heights and the
glass clamp extrusion could be damaged.
7. Tighten the locking plate grub screws.