- 6 -
How to Charge the Batteries
Caution: Only use a battery charger designed for the machine. Failure to do so
can result in damage to the batteries.
Plug the charger red plug to the machine charging plug located near the key switch. Plug
the other charger plug to 220V/120V wall outlet. The charger will automatically begin to
charge the batteries.
How to Install the Squeegee
1.
Put squeegee Release Handle (9) in the UP and locked position.
2.
Position the squeegee blade assembly on the swing arm. Make sure the guide wheels
face the rear of the squeegee.
3.
Place the suction hose over the nozzle. Make sure it fits tight.
How to Install Pad Holder and Brush
1.
Raise the brush pad by stepping on Brush Lift Pedal (12) at the rear of the machine.
2.
With the pad holder/brush in lifted position, insert it into the plate underneath by
turning it counter-clockwise until it locks.
How to Fill the Solution Tank
1.
Open the solution fill cover .
2.
Fill the solution tank with the desired level of clean water.
3.
Add cleaning chemical.
Do not overfill.
How To Operate The Machine
1.
To turn the power on, turn the power switch (5) on.
The power/battery indicator (1) will light up.
2.
Check the battery capacity to see if it is full .If the red
light flash, means that you need to charge the machine
ASAP.
3.
Release the brush pedal (12), turn on the brush motor,
the solution flows also.
4.
Lay down the squeegee release handle (9), press suction
button (3).
Turn off the brush motor when the brush deck is in
the up position.
