49
10. Commissioning
FX-Function
The McCrypt Player is equipped with an effect generator. The output signal can be edited with these effects.
• Push the button FX ON/OFF (17) to activate the effect generator. The button FX ON/OFF (17) is lit.
• Select the desired effect with the button SELECT (18).
• Use the RELAY button (6) to select the GAIN or PARAMETER setting of the effect.
• The GAIN or PARAMETER setting can be changed with the JOG wheel (24).
• Push the button FX ON/OFF (17) to deactivate the effect generator.
REMOTE-Function
The CD player has a REMOTE socket (30). This socket can be used to control playback of the CD player via the
connected mixer (FADERSTART/CROSSFADERSTART). Select the corresponding control mode with the
SINGLE button (21).
• Push and hold the SINGLE button (21). Select the respective control mode with the TRACK dial (3)
(LOCK/TACT/CUE-PLAY).
TOUCH Sensitivity Settings
Observe that the JOG wheel (24) TOUCH function is only active for the SCRATCH function. The JOG wheel (24)
touch sensitivity can be adjusted.
• Switch off the CD player.
• Push and hold the button SINGLE (21) while switching on the CD player with the mains switch (5) until the dis-
play "tOUCH" lights up. Next to the display "tOUCH", the currently set value can be read.
• Touch or slide your hand over the JOG wheel surface (24). The display shows the sensitivity value. Increase
the value by +2 when setting.
• Set the TRACK dial (3) to the new value accordingly.
• Store the settings with the MEMO button (9) and switch off the device with the main switch (5) again.
Switching off the Devices
• Interrupt playback by pushing the PLAY/PAUSE button
(13).
• Switch off the amplifier and any connected mixer.
• Only then switch off the CD player with the main switch (32).
