MBW MK8-75, Operator'S Safety And Service Manual

Page: 46 / 68

46 of 68
6.2.4 Replacement of the
belt(s)
If, as a result of a visual inspection, it appears
that the belts are worn or cracked, replace
them, operating as follows:
●
Remove the fixed guard of
segregation of the belt and loosen the
locknut.
●
Use an appropriate tool on the
tensioning screw (1, fig. 6.3) by
turning counterclockwise to release
tension and allow the removal of belts
(to tension turn clockwise).
●
Remove the worn belts (2), by turning
the pulley, by leveraging with a tool to
remove the belt to be replaced and
replace it with another of the same
size.
●
Mount the new belt(s), by rotating the
pulley to position it correctly;
●
Mount the previously removed fixed
guard for belt segregation.
6.2.5 Engine oil filling
Refer to the engine manual attached and to
the MAINTENANCE CHAPTER OF THIS
PUBLICATION.
The oil filling must be performed with the
machine off after waiting for the cooling of hot
parts.
THE ENGINE OIL TOPPING OFF CAN BE
CARRIED OUT WITH THE MACHINE IN
THE WORKING POSITION.
1. At first proceed by emptying the tank
through unscrewing the nut that
closes the exhaust visible in the figure
(B) below.
2. Then perform the oil topping off after
having checked the level on the
graduated dipstick integrated into the
cap.
3. If necessary top off with oil of the type
shown in the warning (important!) until
the notch in the upper end of the
dipstick.
4. Screw the cap back on and tighten
securely.
6.2.6 Replacement of brake
linings or pads
1. Remove the fixed guard of the belts
area and subsequently the protective
cover of the clutch as well by
tightening
the
three allen
screws;
2. To replace the
brake linings, you
can simply extract
them;
3. To replace the
inner bearing to
the
clutch,
unscrew the
central screw in
order to remove
the clutch and
work from the inside.
4. After these operations replace the
cover and the fixed guard of the belt
area.
Figure 6.3
1
2
Figure 6.5
Figure 6.4