4. Lift the
Driver Side Assembly
into position on the side of
the hardtop. Line up the holes and slide the
5/16”x1”
Button Head Screws
through the hard top, through the
holes in the
Inner Brackets
, and secure using the supplied
5/16” Nyloc nuts
. Do not fully tighten the bolts yet. You will
need 2 people for this step.
Refer to Figures 3 and 4.
5. Install the
Front and Rear Crossmembers
by sliding the
ends of the
Crossmembers
into the ends of the
Driver Side
Assembly
. Ensure the accessory mounting pads are facing
up, the light wiring holes are facing rearward on the
Front
Crossmember
, forward on the
Rear Crossmember
, and the
bolt holes in the
Crossmember
line up with the holes in the
Driver Side Assembly
. Secure the
Crossmember
by
inserting the supplied
5/16”x2.5” Button Head Screws
,
5/16” Nyloc Nuts
and
Washers
. No washers are required
under the head of the screws. Do not tighten yet.
Refer to
Figures 6 and 7.
130717 9/09
Page 3 of 4
Figure 3
Figure 4
Figure 6
Figure 7
Summary of Contents for Off Camber Fabrications 130717
Page 1: ......
