Creasing and perforating machine GoCrease
TM
3000
8
Op Manual
7 Machine maintenance
Once in 6 months check the friction points of the upper bar and side guide ways and lubricate them
if necessary.
8 Machine and transport packaging disposal
Pursuant to the Decree of the Ministry of the Environment No. 381/2001 Sb. as annotated through
Decree No. 503/2004 Sb., and pursuant to the Decree of the Ministry of the Environment and of the
Ministry of Health No. 376/2001 Sb. on the evaluation of the dangerous properties of waste and
pursuant to Act No. 185/2001 Sb on waste.
When the machine completes its service life it can be liquidated together with communal waste. It
has to be dismounted and its parts are sorted to metal and non-metal parts, plastics or rubber
components. These components are then taken to appropriate collecting yards for recycling.
Machine parts are not made from dangerous materials and therefore are handled as communal
waste that does not require special treatment of a professional company.
9 CREASING PRESSURE ADJUSTMENT
9.1 Cover dismounting
Unscrew the lever (15), loosen both screws on the cover (16) and stick the cover out (7) in the
upward direction.
9.2 Adjusting the pressure of the upper creasing bar
Complete this adjustment by means of 3 arrestment bolts. Loosen the nuts (21) and the screw (22).
Stabilize all arrestment bolts in such a position so that the perforating knife evenly touches the
lower bar (6) (position D) along the entire contact surface once the machine has been pressed,
Maximum press power shouldn’t exceed 100 N (22 lbs.). After completing the required settings
tighten the nuts (21). This procedure is applicable for both, creasing and perforating.