Creasing and perforating machine GoCrease
TM
3000
3
Op Manual
1 Identification
Type marking:
GoCrease
TM
3000
Manufacturer:
MBM Corporation
www.mbmcorp.com
2 Specification
The machine is designed for the treatment of common office paper or of paper with similar physical-
chemical properties. The size of sheets is up to 12.6” x 17.7”, the maximum table width is 12.6” and
the maximum basis weight of the processed paper is up to 400g/m
2
.
3 Parameters
a) Paper size
5.8” x 8.3”, 8.3” x 11.7”,
11.7” x 16.5”, 12.6” x 17.7”
b) Max. machine working width
12.7”
c) Front table
Max. distance of stop from creasing/perf. tool
11.8”
Min. distance of stop from creasing/perf. tool
0.9”
d) Back table
Max. distance of stop from creasing/perf. tool
6.3”
Min. distance of stop from creasing/perf. tool
1.1”
e) Crease width
0.03” / 0.04” / 0.05”
f) Built-up area
l = 18.5”
w = 14.6”
h = 14.2” (The lever at the top dead
center)
g) Transportation size
l = 18.5”
w = 14.6”
h = 6.3” (The lever at the bottom dead
center)
h) Basis weight
80 – 400 g/m
²
(creasing)
80 – 250 g/m
²
(perforating)
i) Machine weight
24 lbs.
Note:
The use of the machine requires that the extension size (see point f) be extended by a
working area necessary for handling the machine.
4 Prohibited activities
•
The machine is designed only for the creasing of paper with the above set parameters.
•
The machine can be operated only in protected, enclosed and covered areas (offices,
workshops).
•
It is prohibited to operate the machine if its operation is not continuous; e.g. when it gets
jammed or is damaged.
•
During operation the machine must be covered, complete and in perfect condition.