Creasing and perforating machine GoCrease
TM
3000
5
Op Manual
6.2 Machine operation
The creaser has two sliding stops (3) with tilting stop discs that are adjusted to a required crease
and perforation position according to a millimeter scale. The set position of the stops (3) is secured
with arresting bolts (9). When the minimum or maximum distance of the crease from the paper
edge is required the stops (3) can be exchanged. The lower creasing bar (6) is finished with
longitudinal grooves - 0.03” / 0.04” / 0.05” wide – on either side. Depending on the weight of the
processed paper the crease width is selected according to Article 6.2.3.
6.2.1 Turning the perpendicular guiding of stops
Loosen the screws (13) by approx. half turn and using the rotating handrail (12) select a required
guiding angle. Then tighten the screws (13).
Note: The correct initial position of the guiding line and a 90° angle are set when the crease
axis (b) of the guiding line is identical (collinear) with an opening in the table (a).