IMPORTANT RECOMMENDATIONS
The installation of this equipment should be entrusted to technicians
approved by the vendor and in compliance with standards and rules in force.
Before installing the unit ensure that the circulation and volume of air are
sufficient to allow normal cooling of the condenser and compressor.
Avoid installing the cabinet near major sources of heat or in direct sunlight.
Note that too high an ambient operating temperature can reduce
performance
.
When connecting electrically “earth” continuity must be maintained between
the unit and the supply socket.
For cabinets supplied with a supply cable note that this is a specific part and
should only be replaced with an original part. Being considered as a circuit-
breaker, ensure that the plug is easily accessible as a means of electrical
isolation.
Protection against electrical overload or faults is the responsibility of the
installer. Ensure that a circuit breaker or fuses are fitted in the supply circuit
(See Name plate).
All operations on the electrical or refrigeration circuits, including cleaning
operations should only be undertaken with the unit DISCONNECTED
(unplugged socket).
The air-cooled compressor condenser must be cleaned regularly (every 3 to
6 months).
The unit should not be sprayed or splashed with water:
- Do not use a jet wash on the exterior or technical parts of the unit.
- The equipment must not be installed in the open air or exposed to the
elements.
During any intervention it is imperative that the factory systems are respected
so as not to compromise safety.
The correct operation of this equipment depends on the safety and operating
systems functioning as designed in the factory. We cannot be held responsible
for poor operation that results from inappropriate modifications.
The manufacturer can not be held responsible for usage other than that for
which the equipment was designed.
ALL SP ECIFI CAT IONS AND CHA RA CT E RIST ICS IN T HI S MANUAL MA Y
BE S UBJ ECT T O CHANGE W IT HOUT NOT ICE
