41
6-4 : Removal and installation, and cleaning of folder roller
Two rollers can be removed and installed without using any tool. Thus, cleaning of the rollers and paper
ejection photo sensor can be done easily. As the other two rollers cannot be removed, they should be
cleaned while manually revolving them little by little
.
[ How to remove the folder rollers ]
Remove the rear cover and folding tables 1 and 2. Refer
to the previous page.)
[1] Move down the roller setting lever to the OFF
position.
The roller setting lever is located on both right and
left sides.
[2] Slide the upper folder roller to the left.
(The shaft will come off from the left-side hole.)
[3] Remove the roller from the right-side hole.
By the same procedure, remove the lower folder roller.
-
Clean the four rollers.
After the cleaning, in the reverse order of removal,
set the lower roller first.
[ How to set the folder roller ]
[1] Insert the roller deep to the right.
[2] Slide the roller to the left.
[3] Move up the roller setting lever to the ON position.
Caution
！
If the roller is not firmly set, it may cause
mechanical troubles. If it cannot be fixed,
contact your dealer as shown on the back
cover.
Summary of Contents for 405A
