10
For additional technical information
, go to the “SUPPORT” tab at MBQUART.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
©2018 Maxxsonics USA
PREPARATION
CHAPTER 4
– PREPARE VEHCILE FOR AMPLIFIER MOUNTING PLATE
NOTE - Before installing the amplifier plate with the amplifier in position, you must
prepare the mounting area in the vehicle.
The following instructions show the installation of both the full range and
mono/subwoofer amplifiers. In this installation, you are using only the full range
amplifier. You can upgrade to the subwoofer system which will include a mono
amplifier specifically designed to run the subwoofer.
STEP 1 - Loosen the 16mm nuts that secure the steering column to the support frame shown in
FIG 4.1. These nuts are very hard to loosen. Be careful.
Do not remove these steering column nuts, only loosen to create an 1/8 inch gap between the
nut and the frame shown in FIG 4-2. You will not retighten these nuts until the Chapter 18
section of the installation manual.
(FIG 4-1)
(FIG 4-2)
LOOSEN
DO NOT REMOVE
CREATE A GAP
