STOP FOR THE GRINDING ADJUSTMENT DISK
STOP FOR THE GRINDING ADJUSTMENT DISK
STOP FOR THE GRINDING ADJUSTMENT DISK
STOP FOR THE GRINDING ADJUSTMENT DISK
(Kony - Robur)
(Kony - Robur)
(Kony - Robur)
(Kony - Robur)
The device acts as stop for the grinding adjustment disk
keeping the possibility to do a stepless micrometrical
grinding adjustment.
The appliance is equipped with a nut fitted in a rail beneath
the grinding adjustment disk and with a pin which screws
in the nut.
To adjust the grinding, loosen the pin and turn the disk
until you get the desired point of grinding. To secure the disk in the new position tighten the pin.
To make wider adjustment of the disk loosen completely the pin, turn the disk to get the desired
point of grinding, then put the pin in one of the holes located on the disk on the same side of the
nut and screw the pin tight.
9) WARNINGS REGARDING OPERATION
9) WARNINGS REGARDING OPERATION
9) WARNINGS REGARDING OPERATION
9) WARNINGS REGARDING OPERATION
•
Do not leave the appliances turned ON without coffee in the hopper.
•
In the Grinder-Doser version, avoid pulling the dosing lever partially, always pull it all the way.
•
In the Coffee Grinder version it is essential that nothing
hinders the flow of ground coffee from the outlet in any way
in order to prevent the risk of the appliance stopping.
Consequently, avoid using coffee bags which are too small
with respect to the amount of coffee to be ground. At the end
of each grinding-cycle, shake the handle of the spout for a
complete outlet of the coffee.
•
Do not insert, when filling the hopper with coffee beans, foreign objects. Handle with clean
hands.
•
After any hopper filling and in normal use of the appliance, the hopper lid must be positioned
correctly.
•
FIRST INSTALLATION
For the correct use of the grinding blades, at the first installation or whenever the grinding
blades have been replaced, grind some doses of coffee. Do not use those first doses.
In the Electronic Grinder-Doser version, for the appliance to function at its best, on its first
installation and every time the hopper is cleaned, after having ground a few coffee doses,
clean the inner surface of the funnel with a dry brush.
•
OPERATING RANGE OF THE MOTOR
IN THE VERSIONS WITH SINGLE-PHASE MOTORS, OBSERVE THE DUTY CYCLE
STATED IN THE LABEL LOCATED ON THE SIDE OF THE APPLIANCE.
E. g. : a data on the label 35s ON / 45s OFF points out an allowed duty cycle of 35 seconds
switched on and 45 seconds switched off.
APPLIANCES WITH THREE-PHASE MOTORS ARE ALLOWED FOR CONTINUOUS
WORKING.
In order to achieve good grinding, it is nonetheless recommended to operate the appliance at
intervals, allowing it to operate for no more than 10-15 minutes at a time.
8888
DISK STOPPING PIN
COFFEE GRINDING
ADJUSTMENT DISK
DISK STOPPING NUT
COFFEE
OUTLET SPOUT