77777
PowerCode Technology
TM
is a Registered Trademarks of Code Systems, Inc.
Changing the Remote Control Batteries
The two 3-volt lithium batteries (model CR-1220) supplied in your remote control should last approximately
three years, depending on usage. When the batteries begin to weaken, you will notice a decrease in range
or distance from the vehicle that your remote control operates. Follow the instructions below to change the
remote control batteries.
1. Pry the remote control halves apart.
2. Remove the circuit board from the bottom half of the case and slide the white plastic battery holder out from
under the battery tab releasing the batteries. Remove the old batteries and replace with new ones. Be
sure to observe the (+) sign on the old batteries before removing them to ensure that the new batteries are
inserted properly (battery “+” should be pointed away from the transmitter circuit board).
3. Carefully snap the case halves back together, then test the remote control.
System Maintenance
FCC COMPLIANCE
This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including any interference that may cause undesired
operation.
Note!
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment and void warranty.
