Automatic door-lock/unlock
CX-9 /2007 Version 1.0
Page 11
7.
Testing in the car
This is to be performed after it is installed, but do it
before
you have the relay plastic box well secured
and all the cable perfectly bundled with tire-wraps/tie wires. Trust me…… I have been there…
Get in the car and close the doors as they can’t be locked with an open door. Make sure your car is on
flat ground and does not roll away when releasing the parking brake. Also make sure your panels are in
a save location and the car is not rolling over it or you sitting on it.
Put the ignition switch in the ON. That is one step beyond ACC and the lights on the dashboard will go
on. You can also start the engine and after you release it; that is ON position.
A.
Door-locks should NOT have activated so far. If that did happen however go to chapter 9:
diagnose step 1.
B.
Press and release the parking brake (off) to remove the parking brake. The doors should lock. If
that does not happen go to chapter 9: diagnose step 2.
C.
Press the parking brake (on), the doors should go to unlock. If that does not happen go to
chapter 9: diagnose step 2.
D.
You should be able to repeat step B and C, but don’t try to get your doors go wild
E.
Before you switch off the contact make sure that parking brake is pressed (on). The doors
should be unlocked. When switching off, door-locks should not activate. If that does happen go
to chapter 9: diagnose step 1.
F.
Same as E, but then with parking brake is released (off). The doors should be locked. When
switching off, door locks should not activate. If that does happen however go to chapter 9:
diagnose step 1. You will have to unlock manual in any case.
If all above steps pass you are ready to finalize the installation following the steps in chapter 8.
