Automatic door-lock/unlock
CX-9 /2007 Version 1.0
Page 10
6.
Install in the CX-9
There are some good descriptions, coming from Mazda to directly on how to remove the necessary
panels as well as locate the cable connections. I have included a copy of the information in Appendix-C
that is coming from these instructions. I hope it will not get me in copyright trouble for including instead
of referencing, but the information is coming from Internet, I use source reference and I am sure Mazda
wants happy drivers. Thank you Mazda!
Steps
Disconnect the battery (as precaution) - See Appendix-C
a.
Disconnection with clear radio-channels and seat-memory.
Remove the panels - See Appendix-C
Appendix-C shows the Body Control Module (BCM). It is located at the front, behind the kick-
panel at the driver side:
a.
The white 30-pin connector at the top
b.
The white 6-pin connector underneath
Locate the right wires with the right colors and connect the wires from the circuit using the
wire-taps as follows:
o
Grey wire: connect to Violet/White (v/w) wire on 30 pin connector; PIN 3R
o
White wire: connect to Green (G) wire on 30 pin connector; PIN 1A
o
Red wire: connect to Black/Yellow (B/Y) wire on 6 pin connector; Pin 4A
o
Black wire: connect to ground/chassis connection on the car
After connection the wires, Connect the Battery - See Appendix -C
