Robotic Pool Cleaner
Swash CLX / TCX
|
User Instructions
11
8. TROUBLESHOOTING
If the suggest solutions do not solve the problem contact your dealer
Symptom
Possible reason
Corrective action
1. Cable twisting
or cable coils up
• Obstruction in pool
• Excess cable in the pool
• Filter bag/cartridge dirty
• In all abovementioned cases
• Remove obstruction in pool.
• Remove excess cable out of the pool.
• Clean filter bag/cartridge.
• Straighten cable and lay in sun periodically.
2. The Pool Cleaner
is moving in
circles
• Dirt stuck in moving parts
• Clogged filter bag/cartridge
• Power supply incorrectly
positioned
• Incorrect mounting of bottom lid
• Algae or pool water is out of Spec
• Remove dirt from moving parts.
• Clean filter bag/cartridge.
• Place power supply in a position so that the
Pool Cleaner can reach all walls.
• Lock bottom lid in the right position.
• Correct pool and water conditions.
3. The Pool Cleaner
does not cover
the entire pool
• Power supply incorrectly
positioned
• The handle is not positioned
in accordance to the pool
conditions
• Place power supply in a position so that
the Pool Cleaner can reach all walls.
• You may enhance the pool coverage by adjusting
the handle float. For optimal pool coverage the
Pool Cleaner should turn on the floor at 90° angle
(the Pool Cleaner rotates twice before completing
the 90° turn).
1. If the Pool Cleaner does not complete a 90° turn,
shift the float opposite to the cable’s entry–side
towards the handle center.
2. If the Pool Cleaner turns in an angle wider than 90°,
shift the float on the cable’s entry-side towards
the handle center.
4. The Pool Cleaner
does not climb
walls
• Filter bag/cartridge is full
• Algae on walls
• Water temperature too low
• Brushes worn
• Slippery ceramic wall tiles
• Debris caught around impeller
• The Pool Cleaner is too light -
trapped air
• Unsuitable pH level
• Empty and wash filter bag/cartridge.
• Brush walls.
• Ideal water temperature between 6°-34°C / 43°-93°F.
• Replace brushes - contact your dealer.
• Consult with your dealer about special brushes.
• Remove impeller tube. Clean impeller.
• Turn the Pool Cleaner upside down under water
to remove trapped air.
• Check pH level between 7 and 7.8.
5. Motors
not working
• Impeller blocked
• Drive system blocked
• Electrical problem - motor unit,
cable or power supply
• Remove impeller tube and clean impeller.
• Clean tracks and wheels.
• Consult with your dealer and Service Center.
6. The Pool Cleaner
will not sink
• Air caught in filter bag/cartridge
• Special combined climbing
brushes are dry
• Turn the Pool Cleaner upside-down under
water to remove trapped air. Wash the filter bag/
cartridge.
• Open two inlet flaps in the bottom lid to remove
dirt and/or trapped air.
• Soak brushes in water.
7. Power supply
or power supply
switch light is
not working
• Not plugged properly or
non - functioning socket
• Check power to the socket and reconnect
the Pool Cleaner.
