9
NOTES:
■
Do not force excess drain hose back into the rear of the
washer.
■
To avoid siphoning, do not seal or put more than 4½"
(114 mm) of the drain hose into drainpipe or standpipe.
■
If the washer faucets and the drain standpipe are recessed,
put the hooked end of the drain hose in the standpipe as
shown. See illustration C.
Level the Washer
Properly leveling your washer avoids excessive noise and
vibration.
1.
Check the levelness of the washer by placing a level on the
top edge of the washer, first side to side, then front to back.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this
step until washer is level.
2.
Make sure all four feet are stable and resting on the floor.
Then check that the washer is level (use a level).
3.
After the washer is level, use a 9/16" open-end wrench to turn
the nuts on the feet tightly against the washer cabinet.
IMPORTANT:
All four feet must be tightened. If the nuts are
not tight against the washer cabinet, the washer may vibrate.
4.
The washer should not move front to back, side to side, or
diagonally when pushed on its top edges.
5.
Slide the washer to its final location.
6.
Confirm the levelness of the washer.
Installing Pad Strips
NOTE:
For PD Models only.
1.
Take the 2 foam pad strips from bag.
2.
Remove the tape from the back of the adhesive pads.
3.
Install the pads on the left and right inside walls of the coin
vault, leaving about 1/4 to 1/2 inch of space near the front
edge of the vault to allow room for the coin box to lock into
position.
Complete Installation
1.
Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See “Electrical Requirements.”
2.
Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3.
Check that you have all of your tools.
4.
Dispose of/recycle all packaging materials.
5.
Check that the water faucets are on.
6.
Check for leaks around faucets and inlet hoses.
7.
Plug into a grounded 3 prong outlet.
8.
To test and to clean your washer, measure 1/2 the detergent
manufacturer’s recommended amount of High Efficiency (HE)
detergent for a medium-size load. Pour the detergent into the
detergent dispenser. Select any cycle and allow the washer to
complete one whole cycle.
A. Foam pad strips
A
Summary of Contents for W10353871A
Page 17: ...17 S CURIT DE LA LAVEUSE...
