Disassembly Procedures
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
8
16022983 Rev. 0
©2004 Maytag Appliances Company
Door Removal
1. Make sure the main unit is OFF and the powercord is
unplugged.
2. Unplug the door wire harness from the lower right
corner of the door and the lower left corner of the
personal beverage vendor.
3. Open the door wider than a 90° angle.
4. Lift the door up, releasing the door hinges from the
hinge posts.
Dispensing Assembly
1. Remove Door (see Door removal procedure)
2. Remove Sling assembly by unhooking two hooks
from sling at top of chute opening and removing from
velcro from left side of cabinet.
3. Remove screws holding dispenser assembly in place,
5 screws on front of dispensing assembly and 4 on
left hand side of dispenser.
4. Slide dispenser assembly out and unplug ribbon
connector from dispenser assembly.
Temperature Control
1. Remove single screw at bottom of temperature
control.
2. Slide down temperature control to expose wiring and
sensing bulb.
3. Disconnect wires from temperature control. Note
location of wires when removing temperature control.
4. Slide sensing capilary tube out of sleeve while
removing temperature control.
5. Reverse procedure to reassemble.
Ribbon Connector
1. Remove dispenser assembly (see dispenser
assembly removal).
2. Unplug ribbon connector from dispenser assembly.
3. Remove plug seal from inside back of cabinet holding
connector in place.
4. Remove machine compartment screws from back
side of machine compartment.Remove machine
compartment cover.
5. Remove cover from main board by removing screws.
6. Unplug ribbon connector from board and slide it
through hole in cabinet.
7. Reverse procedure to reassemble.
Summary of Contents for Skybox MBS1976AAB
Page 11: ...A 1 Appendix A...
Page 28: ...B 1 Appendix B...