14
Remove Shipping Brackets
Soft-Mount Models
IMPORTANT:
Shipping brackets must be removed before putting
the washer into service. Failure to do so can cause damage to the
washer. Save the brackets for use if moving the washer in the future.
1.
Remove the front panel and rear panel.
2.
When the washer is lifted off the pallet, make sure the washer
does not come down on the floor with either of the rear corners
first. The side panel can be damaged.
3.
Mount the feet.
4.
Use the feet to level the washer.
5.
Replace both panels.
1 – Front metal shipping brackets
2 – Rear metal shipping brackets
3 – Front panel
4 – Rear panel
Electrical Connection
The power supply of the liquid soap pump system must be
connected to an external electrical source. Only qualified technicians
can make the electrical connection according to local codes.
Instructions for the correct connection can be found on the wiring
diagram located in a plastic bag inside the cabinet. Do not connect
the liquid soap pump system in the washer.
Electronic Controller with MC7 and Graphic Display
PN Models:
For electrical connection of supply control signals,
a plastic box is located on the rear of the washer (see illustration
below, position 1). There is also a terminal box with LED’s that signal
activation of the respective pump (position 3).
A label for electrical connections is located on the back side of the
terminal box cover (see illustration below). Detailed information on
connecting signals can also be found on the electric schematic of the
washer. Signals for the supply pump control are 24V AC. Maximum
current for control circuits of pumps must be limited to 10mA. Insert
the cable for connection of pump control signals through the plastic
cable strain relief (position 2). After connection of conductors to the
respective positions of the connector “P” (screw clamps), attach the
cable by tightening the cable strain relief and replace the cover on
the box. For details about liquid soap supply system programming,
see the Programming Manual.
1
2
3
Electrical Connection Label
Electrical Connection (cont.)
4
2
3
1
Soft-Mount Model Shown