PAGE 5
FOR SERVICE TECHNICIAN’S USE ONLY
DO NOT REMOVE OR DES
TROY
When rotating the cycle selector knob,
each click “indent” toggles the “Done”
LED as well as the associated cycle LED.
Press the
POWER
button at any time
to exit UI test mode.
Washer will exit UI test mode after 5
minutes of inactivity or unplugging the
power cord.
SOFTWARE VERSION DISPLAY MODE
To access Software Version Display Mode, perform
steps 1 and 2 of Activating the Service Diagnostic
Modes. Turn the cycle selector knob until the status
LEDs or display (if it exists) correspond as follows:
“Rinse, Spin, and Done” LEDs On,
“
07
” Displayed on 7-segment (if exists)
07
Sensing Soak Wash Rinse Spin Done
NOTE:
LED names may vary between makes
and models.
Press the
START
button to begin software
display mode.
Upon entering the software version display
mode, the Major, Minor, and Test version
numbers for the software are displayed by
alternating the state of the status LEDs and
display (if display exists) in one second
intervals; the process repeats following
a pause.
For example, if the s/w version is 02.01.07,
the following sequence would be displayed:
32 16 8 4 2 1 Display
02
0 1
07
Sensing Soak Wash Rinse Spin Done
Press the
POWER
button at any time
to exit software version display mode.
TACHOMETER VERIFICATION MODE
To access Tachometer Verification Mode,
perform steps 1 and 2 of Activating the Service
Diagnostic Modes. Turn the cycle selector
knob until the status LEDs or display (if exists)
correspond as follows:
“Wash and Done” LEDs On, “
09
” Displayed
on 7-segment (if exists)
09
Sensing Soak Wash Rinse Spin Done
NOTE:
LED names may vary between makes
and models.
Press the
START
button to begin tachometer
verification mode.
Tachometer verification uses the status
LEDs to represent the tachometer
frequency (basket RPM).
For example, slowly turn the basket
by hand; as the basket turns, the DONE,
SPIN, RINSE, and WASH status LEDs
will illuminate one at a time in a visually
repeating cycle. The LED timing is derived
from the tachometer signal itself.
Press the
POWER
button at any time
to exit tachometer verification mode.
CUSTOMER VIEWABLE FAULT CODES
There are 3 fault codes that may be visible to the
customer indicated by the following Status LEDs:
WASH LED ON (Long Fill Fault) – Refer to
“No Fill, Long Fill” on page 7 for information.
SPIN LED ON (Long Drain Fault) – Refer to
“Long Drain” on page 7 for information.
LID LOCK LED FLASHING CONTINUOUSLY
(Lid Lock Fault) – Refer to “Lid Lock Fault”
on page 6 for information.
FOR SERVICE FAULT AND ERROR CODES,
CONTINUE TO PAGES 6 AND 7
