PAGE 4
FOR SERVICE TECHNICIAN’S USE ONLY
DO NOT REMOVE OR DESTROY
AUTOMATIC TEST MODE (Page 8)
To access Automatic Test Mode, perform steps
1 and 2 of Activating the Service Diagnostic
Modes. Turn the cycle selector knob until the
status LEDs or display correspond as follows:
“Spin” LED On, “
02
”
Displayed on 7-segment
02
Sensing Soak Wash Rinse Spin Done
Press the
START
button to begin the automatic
test. See page 8 for order of automatic test.
Upon entering the automatic test mode, the
washer will perform an automatic test with
water cycles to check major washer functions.
Pressing the
START
button will manually
advance to the next step.
Press the
POWER
button at any time
to exit automatic test mode.
IMPORTANT:
Lid must be closed with lid lock
enabled to perform test.
MANUAL TEST MODE (Page 9)
To access Manual Test Mode, perform steps
1 and 2 of Activating the Service Diagnostic
Modes. Turn the cycle selector knob until the
status LEDs or display correspond as follows:
“Spin & Done” LEDs On, “
03
” Displayed
on 7-segment (if exists)
03
Sensing Soak Wash Rinse Spin Done
Press the
START
button to enter Manual Test
Mode. See page 9 for manual test mode.
Upon entering the manual test mode,
the washer will have all outputs OFF.
The cycle selector knob is used to select
the output to be tested.
The
START
button will activate/deactivate
the selected output.
When the selected output is activated, the
corresponding status LEDs flash ON & OFF.
Press the
POWER
button at any time
to exit manual test mode.
IMPORTANT:
As a safety feature, the lid
must be closed with lid lock enabled to
activate either Agitate or Spin Test.
NOTE:
Multiple outputs may be activated
simultaneously.
NOTE:
Outputs left on will time out after 5 minutes.
CALIBRATION MODE
IMPORTANT:
Calibration must be performed
when any of the following components have
been replaced: Main Control, Basket, Drive
Assembly, Suspension, Motor, and Capacitor.
Not performing calibration will result in poor
wash performance.
To access Calibration Mode, perform steps
1 and 2 of Activating the Service Diagnostic
Modes. Turn the cycle selector knob until the
status LEDs or display correspond as follows:
“Rinse” LED On, “
04
” Displayed on 7-segment
04
Sensing Soak Wash Rinse Spin Done
Press the
START
button to begin washer
calibration. All status LEDs will turn on.
Do
NOT
interrupt calibration, disturb washer,
or remove power; otherwise, calibration
must be repeated.
Lid must be down to perform test.
Basket must be empty to perform test
(no water or clothes).
Calibration cycle runs for approximately
2-4 minutes. Cycle completes when door
unlocks and washer enters standby mode.
UI TEST MODE
To access UI (User Interface) Test Mode, perform
steps 1 and 2 of Activating the Service Diagnostic
Modes. Turn the cycle selector knob until the
status LEDs or display correspond as follows:
“Rinse & Spin” LEDs On, “
06
” Displayed
on 7-segment (if exists)
06
Sensing Soak Wash Rinse Spin Done
NOTE:
Status LED names may vary between
makes and models.
Press the
START
button to begin the UI test.
Upon entering the UI test mode, all LEDs
and display (if it exists) will be turned ON.
Pressing the
START
button will turn on
and off the display (if it exists) and all
status LEDs, or toggle the state of each
status LED independently. (Example: if 2
are on, and 3 are off, then 2 will be turned
off and 3 turned on.)
