Maytag MVWB850WB - 28" er Washer, Use & Care Manual

Page: 13 / 40

13
Vacation, Storage, and Moving Care
Install and store your washer where it will not freeze. Because
some water may stay in the hoses, freezing can damage your
washer. If storing or moving your washer during freezing weather,
winterize it.
Non-use or vacation care:
Operate your washer only when you are at home. If you will be on
vacation or not using your washer for an extended period of time,
you should:
Unplug washer or disconnect power.
■ ■
Turn off the water supply to the washer. This helps avoid
■ ■
unintended flooding (due to a water pressure surge) while
you are away.
To winterize washer:
1. Shut off both water faucets.
2. Disconnect and drain water inlet hoses.
3. Put 1 qt (1 L) of R.V.-type antifreeze in the basket.
4. Run washer on the Rinse & Spin setting for about 30 seconds to
mix the antifreeze and remaining water.
5. Unplug washer or disconnect power.
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet hoses. Turn
on both water faucets.
2. Plug in washer or reconnect power.
3. Run the washer through the Bulky cycle to clean the washer
and remove the antifreeze, if used. Use only HE detergent.
Use
1
/
2
the manufacturer’s recommended amount for a
medium-size load.
To transport the washer:
1. Shut off both water faucets.
2. Disconnect and drain water inlet hoses.
3. If the washer will be moved during freezing weather, put 1 qt
(1 L) of R.V.-type antifreeze in the basket. Run washer on the
Rinse & Spin setting for about 30 seconds to mix the antifreeze
and remaining water.
4. Disconnect the drain from the drain system.
5. Unplug the power cord.
6. Place the inlet hoses into the basket.
7. Drape the power cord and drain hose over edge into the
basket.
8. Place foam packing ring from the original shipping materials in
the top of washer. If you do not have the original foam packing
ring, place heavy blankets, towels, etc. into basket opening.
Close the lid and put a piece of tape over the lid and down
to the front of the washer. Keep lid taped until the washer is
placed into the new location.
Reinstalling the washer
1. Follow the “Installation Instructions” to locate, level, and
connect the washer.
2. Run the washer through the Bulky cycle to clean the washer
and remove the antifreeze, if used. Use only HE detergent.
Use
1
⁄
2
the manufacturer’s recommended amount for a
medium-size load.