Maytag MGS5752BD, Service, Page: 27 / 55

©2005 Maytag Services
16026293 27
To avoid risk of electrical shock, personal injury or
death; disconnect power and gas before servicing.
Disassembly Procedures
Orifice Holder
1. Remove maintop, see "Maintop Removal" procedure.
2. Disconnect tubing from surface burner lower
assembly.
3. Remove orifice holder from gas tubing.
4. Reverse procedures to reassemble.
NOTE: Perform gas leak test.
Manifold and Top Burner
1. Remove maintop, see "Maintop Removal" procedure.
NOTE: If replacing manifold only, skip step 2.
2. Loosen and disconnect fittings securing surface
burner tubing to burner assembly and manifold.
3. Remove bolt(s) securing surface burner valve(s) to
manifold.
4. Remove nut securing shut-off valve to manifold.
5. Reverse procedures to reassemble.
NOTE: Perform gas leak test.
Shut-Off Valve
1. Remove maintop, see "Maintop Removal" procedure.
2. Remove screws securing back panel to chassis.
3. Remove nut securing shut-off valve to gas tubing.
4. Remove nut securing shut-off valve to regulator.
5. Reverse procedures to reassemble.
NOTE: Perform gas leak test.
Regulator
1. Disconnect power before servicing.
2. Remove range from installation position, see "Move
and/or Replacing Range" procedure.
3. Disconnect tubing from regulator.
4. Remove nut securing shut-off valve to regulator.
5. Remove screws securing bracket to back of unit.
6. Remove screws securing regulator to support
bracket.
7. Reverse procedures to reassemble.
NOTE: When reconnecting supply line to regulator, use
pipe dope compound to seal the connection.
NOTE: Perform gas leak test.
Rocker Switch
1. Remove control panel, see "Control Panel" procedure
for removal.
2. Disconnect and label wire terminals from rocker
switch.
3. Squeeze tabs on rocker switch and push outward to
release from control panel.
4. Reverse procedure to reinstall rocker switch.
Removing and Replacing Range
1. Remove power from unit.
NOTE: To avoid countertop damage, do not move
range forward until range has been raised
enough to clear all cabinetry.
2. Pull the range forward out of the cabinet opening.
3. Disconnect or unplug the power cord leading from
unit to fuse box or junction box depending on unit.
4. Replace the oven using the installation instructions
and anti-tip bracket(s).
Surface Burner
1. Disconnect power before servicing.
2. Remove surface grates.
3. Remove screws securing burner to burner lower
assembly.
4. Reverse procedures to reassemble.
Ignitor
Broil Burner
Regulator
Shutoff Valve
Bake Burner
Ignitor
Gas Tubing/
Orifice Holder
Burner Valve
Bracket
Burner Base
Burner Cap
Gas
Crossover
Surface Burner Lower Assembly
1. Remove maintop, see "Maintop Removal" procedure.
2. Disconnect tubing from surface burner lower
assembly.
3. Reverse procedures to reassemble.
Maintop Assembly
1. Remove power from unit.
2. Remove range from installation position, see
“Removing and Replacing Range” procedure.
3. Remove burners, see “Top Burner" procedure.
4. Remove screws securing maintop to range chassis.
5. Label and disconnect wiring.
6. Reverse procedure to reinstall maintop assembly.