Important Safety Information
4
16021520 Rev. 0
©2002 Maytag Appliances Company
WARNING
!
Read the following information to avoid possible exposure to microwave radiation:
The basic design of the Amana Microwave Oven makes it an inherently safe device to both use and service.
However, there are some precautions which should be followed when servicing the Radarange to maintain this
safety. These are as follows:
8.
Do not for any reason defeat the interlock
switches there is not valid reason for this action
at any time; nor will it be condoned by Amana.
9.
IMPORTANT: Before returning a unit to a
customer, be sure to check for proper switch
interlock action.
10. Before returning a unit to a customer, be sure that
the door spacing is reasonably uniform along the
top, bottom, and sides, and that it measure
1/8" or less.
11. The Amana Microwave Oven should never be
operated with any components removed and/or
bypassed or when any of the safety interlocks are
found to be defective, or when any of the seal
surfaces are defective, missing, or damaged.
12. All Amana microwave ovens meet all
requirements of the radiation control for Health
and Safety Act of 1968. Due to measurement
uncertainties, the maximum leakage for the field
will be 4mw/cm
2.
13. To ensure that the unit does not emit excessive
microwave leakage and to meet the Department
of Health and Human Services guidelines, check
the oven for microwave leakage using the Narda
model 8100, 8200 Holaday HI1500, HI1501, or
Simpson 380M leakage monitor as outlined in the
instruction. The maximum leakage level allowed
when following those instructions is 4mw/cm
2
.
14. If servicer encounters an emission reading over
4mw/cm
2
, the servicer is to cease repair and
contact the Amana Service Department
immediately for further direction. Amana
Manufacturing will contact the proper Government
Agency upon verification of the test results.
1.
Always operate the unit from an adequately
grounded outlet. Do not operate on a two-wire
extension cord.
2.
Before servicing the unit (if unit is operable) perform
the microwave leakage test.
3.
The oven should never be operated if the door does
not fit properly against the seal, the hinges or hinge
bearings are damaged or broken; the choke is
damaged, (pieces missing, etc.); or any other
visible damage can be noted. Check the choke
area to ensure that this area is clean and free of all
foreign matter.
4.
If the oven operates with the door open and
produces microwave energy, take the following
steps:
A. Tell the user not to operate the oven.
B. Contact Maytag Amana Manufacturing
immediately.
5.
Always have the oven disconnected when the outer
case is removed except when making the "live"
tests called for in the Service Manual. Do not
reach into the equipment area while the unit is
energized. Make all connections for the test and
check them for tightness before plugging the cord
into the outlet.
6.
Always ground the capacitors on the magnetron
filter box with an insulated-handle screwdriver
before working in the high voltage area of the
equipment compartment. Some types of failures
will leave a charge in these capacitors and the
discharge could cause a reflex action which could
make you injure yourself.
7.
Always remember that in the area of the
transformer there is HIGH VOLTAGE. When the
unit is operating keep this area clear and free of
anything which could possibly cause an arc or
ground, etc.
Summary of Contents for 1324704M
Page 4: ......
Page 40: ...2002 Maytag Appliances Company 16021520 Rev 0 B 1 Appendix B...
