4
9
1
9
ENG
Assembly
Mains Connection
Step 5: Assembly of the Seat and Seat Tube
Place the seat (4) onto the pivot of the seat tube (9) and tighten the screws of the seat bracket.
Then insert the seat tube (9) into the mount on the base frame (1) and adjust it to the desired height using the
knob.
Mains Cable
Insert the connector of the supplied mains adapter cable into the socket located on the front of the main hous-
ing. Then connect the mains adapter cable to a power socket.
WARNING
This device is only to be connected to an earthed socket installed by a qualified electrician. Do not use a socket
strip. If an extension cable is required, then it must comply with DIN standards, VDE regulations and guidelines,
technical rules issued by other European Union member states or other states which are party to the Agreement
on the European Economic Area.
Connecting the Device
CAUTION:
Before connecting the mains adapter to the device, always check that it is the mains adapter supplied with the
device. Using a different mains adapter may damage the electronic components of the device, for which the
manufacturer assumes no liability.
Always connect the mains adapter cable to the training device before connecting it to a power socket. If you
want to disconnect your training device from the power supply, always disconnect the mains adapter cable from
the power socket first.
Switching on the Device
First connect the mains adapter cable to the training device and then plug it into the power socket. The cockpit
will turn on automatically. If the training device is already connected to the mains, but the cockpit is in stand-by
mode, activate it by pressing any key or by moving the pedals.
Turning off the Device
As soon as you have finished training you must disconnect the training device from the mains. Always remove
the plug from the power socket first and then remove the connector of the mains adapter cable from the device.
