Maxxus Multipress 9.1, Installation Manual

Page: 17 / 38

Zugseil (69) - Länge 3.590 mm
Kette mit 2 Karabinerhaken (62)
10
9
58
52
58
69
62
66
64
65
50
68
9
9
9
10
17
ENG
Assembly Step 8
Attach foot plate (68) using the hexagonal screws M10x25 (50) and two washers Ø10 (9) to the lower cross-
pipe.
Dismantle the distance ball from the end of pulley cable (69) by loosening the nut and removing the hexagonal
screw. Undo the U-bolt from the end of the cable. Now remove the distance ball and the round holding plate.
Now take a chain with a carabiner hook on each end (62). Connect a carabiner hook to the eyelet on the end of
the pulley cable (62). Hook the other carabiner hook to the eyelet on the rear stand pipe.
Feed the other end of the pulley cable (69) upwards and round the lower roller (R1) on double roller (57).
Now take the end of the pulley cable (69) back down and from below feed it through roller (R2) on the stand
pipe.
Take the end of the pulley cable (69) back upwards and through the lower roller (R3) on the cross-roller (59).
Then feed the end of the pulley cable (69) under the large roller (64) from behind through the opening in the foot
plate (68).
Place the single roller (R1) back in the butterfly base frame so that the pulley cable (76) goes under the roller.
Fix the distance ball back onto the end of the pulley cable (69).
Assembly - Multipress