GARNISH RING
GARNISH RING
STEP 7
Complete the installation by placing any excess wiring
to the inside of the roof opening and sliding the Garnish
Ring into position. Fasten in place by using the four
painted flat head screws provided.
NOTE:
DO NOT probe or tamper with the thermostat
sensor or IR sensor shown in illustration #6 above.
7
CONGRATULATIONS!!!
You have successfully completed the
installation of your new
MAXXFAN
Deluxe.
If you have questions, please visit
AIRXCEL.com or contact
Customer Service at 316.832.4357.
6A
6B
STEP 6
The interior Garnish Trim Ring must be trimmed to fit
your particular RV roof thickness. To accomplish this,
measure the distance from the vehicle ceiling surface to
each corner of the
MAXXFAN
Control Plate.
Most RV roofs have some slope, so measuring each
corner is necessary. The Garnish ring should be cut
1/4” to 1/2” longer than the dimensions measured at
each corner.
In Picture #6 below, the installation measures 3 1/2”
from the ceiling (this is an example only) to the Control
Plate. After adding 1/2” as in this example, using a ruler,
place a mark at 4” on each corner of each side of the
Garnish Ring (refer to 6A, right). Once marked, draw a
line connecting all 4” marks on the outside of the Garnish
ring and trim accordingly (refer to 6B, right).
FOR REMOTE CONTROL MODELS:
Refer to
the Operating Instructions for use and testing of your
remote control. Install two AAA batteries, follow
instructions, aim remote at the ceiling unit and test
your fan. The Remote Control comes with a cradle
for wall mount storage of the Handheld Remote
Control. Mount the cradle to your wall using the (2)
#6 screws provided. Remote may be placed into the
wall cradle for storage.
THERMOSTAT
SENSOR
3 1/2”
CEILING
6
MEASUREMENTS STATED IN STEP
6 ARE USED AS AN EXAMPLE FOR
ILLUSTRATION PURPOSES ONLY
3
